I found the best way to fix sharp corners was to use a fillet or chamfer when I hade the space. These properties will cause the blade to pull the copper from its backing, which will ecentually ruin the entire circuit. The most problematic details are sharp corners and small details in close vicinity to each other. I found the vinyl cutter to be a bit finicky when cutting copper, so you want to design your circuit to limit the chances of failure. These can be a bit confusing at first, but there are a number of resources out there for circuit design, so I recommend doing a bit of research to try to find resources that fit your taste and learning methods.įinally, I 100% recommend checking out the electric circuits guide from hyperphysics (my favorite resource for pretty much everything), which has information on everything you need for analog circuitry. capacitors (I haven't used any in my examples, but they come up a lot and it's a good thing to understand)įor basic circuit design, it's also important to understand components working in series and parallel and Kirchoff's Laws.
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |